![]() Still trying to boot after an hour wait the next day, looks like I might have to warm it up a lot longer before it was able to boot last night. After power cycle and if it booted successfully with 2 beeps, it seems running fine afterward, only good until next cold boot. Most the time it hung at various places on the 1st boot(post code B2 or during decompress/booting to kernel). It seems it has a higher chance to boot if the processor is heated up hours before it is ready to boot (without fan and leave it on even if it hung). We have tried to put a 120 ohm resistor between the degraded clock signal and 0V, and that seems to solve the problem, the computer boots again.Ĭontinuously trying in the evening, I actually got it to boot with the resistor back to 120 Ohm (fine tune might be needed for a specific system). We have measured that the LPC CLK signal is clearly degraded, and most often that the negative cycle transistor is broken, meaning that the clock signal is swinging between 1.6 and 3.3V, not 0V and 3.3V. I checked which pins connected to which pins and this is what i got: When i tried to read the chip with the pin connections recommended in the guide with my Minipro TL866 i got an error message saying that no chip was detected. Now i thought you might like to know that the JSPI1 pins on my mobo connected to different pins on the bios chip to the guide at the beginning of this thread. So i've run out of options really, i'll likely just buy a new NAS (obviously not a QNAP again due to extortionate prices they want to have the mobo replaced) I'll likely forgo all the bells and whistles and go for a Drobo instead. ![]() The NAS still gets stuck with the LED screen saying 'System Booting>' with no beeps at all, my connected monitor is blank with no POST message or any message at all for that matter. ![]() Please report this on IRC at (channel #flashrom) orįor anyone who may be interested i also have successfully flashed the Bios chip on my TS-453 Pro (QW37 Rev 1.7 motherboard) with a Minipro TL866A and 1.8v adapter. flashrom cannot readĪnd may never be able to write it, hence it may not be able to completelyĬlone the contents of this chip (see man page for details).Įrasing and writing flash chip. This chip may contain one-time programmable memory. Code: Select all Found Winbond flash chip "W25Q64.W" (8192 kB, SPI).
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |